Famco Crown Repair Nationwide

Famco Crown Repair: The Marietta Owner’s Guide

If your Famco chimney cap crown is cracked, rusted through, or letting water run down the flue, we stock Famco-compatible crown repair parts on our service trucks and install them throughout Marietta on a scheduled basis, with most jobs running between $285 and $540 including parts and labor. The quick version: we’ll match your Famco model, give you the real price before we start, and stand behind it in writing. Most homeowners discover the problem the same way: a rust-colored drip stain on the fireplace wall after a heavy Georgia rain, or chunks of corroded metal sitting in the firebox after a windstorm.

Call (478) 796-8742

The crown (sometimes called a chase cover or top plate) is the metal lid that seals the top of a prefab chimney. Famco makes them in galvanized steel, stainless, and copper across a wide range of sizes, and when they fail, they fail fast once water starts sitting on them. In Marietta’s humidity and summer thunderstorm cycles, a compromised crown goes from minor leak to interior damage quicker than most people expect.

Key Takeaways:

• We install Famco-compatible crowns with a written price before work starts
• Typical installed cost in Marietta: $285 to $540 depending on size and material
• Every repair carries the Kingswell Guarantee in writing
• Call (478) 796-8742 and a live person answers, day or night

Which Famco Models This Applies To

Famco is one of the better-known names in chimney termination caps and chase covers, and we work with their full range of sizes. The critical detail most homeowners miss: Famco crowns are not one-size-fits-all. They are measured to fit the outside dimensions of your chimney chase, not the flue pipe inside it. We regularly see Marietta homeowners who ordered a crown based on the flue diameter sitting inside, only to find the crown hangs off the chase by three inches or won’t drop over the top at all.

Before we order or pull a crown, we measure the outside of the chase across both width and depth, and we check the top plate for the flue opening(s). Famco crowns come in single-flue and multi-flue layouts, and the spacing between flues matters. We also check the overall condition of the chase top because a new crown on a water-damaged chase is money wasted. If the underlying metal top is rusted through, the right fix is a full replacement crown that functions as both the seal and the new top. We carry common Famco sizes on the truck for single-flue prefab units; oddball sizes get ordered and installed within the week.

On the OEM-versus-aftermarket question: for the crown itself, most of what we install is genuine Famco or a direct-compatible equivalent from a recognized chimney-trade supplier. The distinction matters less for fit than for material. Famco crowns come in galvanized, which is fine for a budget, but stainless and copper hold up far longer in Marietta’s climate. Ashby Chimney Marietta is an independent service provider, not affiliated with Famco, but we source their products through the same trade channels any dealer uses, and we warranty the total installation ourselves.

Signs Your Famco Crown Repair Is Failing

• Water staining on the fireplace wall or ceiling near the chimney chase. This is the most common first sign. The crown is the only thing stopping rain from pouring directly down the chase and onto the firebox structure below.
• Rust flakes or chunks in the firebox after a hard storm. A galvanized crown corrodes from the inside out. Once you see debris in the firebox, the crown is past cleaning up and into replacement territory.
• A draft you can feel with the damper closed. If cold air comes down the chimney in winter, the crown has likely separated from the chase top, letting air bypass the damper and drop straight into the room.
• Visible rust trails or holes when viewed from the ground. A walk around the house with binoculars is sometimes all it takes. If the top of the chase is scaling or shows daylight through it, no amount of sealing fixes it.
• The crown has pulled away from the chase on one corner. High winds around Marietta, especially homes near Kennesaw Mountain, can torque a crown off its fasteners over time. Hairline separation becomes full water entry within one season.

None of these get better on their own. By the time a crown repair is on your radar, the damage clock is already running. That said, not every failing crown tears out the entire firebox in a week. Some can limp along through a dry stretch. The right call is an inspection, not a guess.

Replacement Cost & What’s Included

In Marietta, a Famco crown replacement on a standard prefab chimney runs $285 to $540 fully installed. A galvanized single-flue crown on a small chase sits at the lower end. A stainless or copper crown on a larger multi-flue chase with existing rust damage to the top plate runs higher, sometimes by a hundred or more depending on the size of the panel we need to fabricate. We give the exact price before we start, and the number we quote is the number you pay.

Here’s what that includes:

• The crown or chase cover matched to your Famco configuration
• Removal and disposal of the old crown
• Sealing and fastener replacement on the chase top
• Verification that the flue terminations seat correctly
• A written guarantee on the completed repair

Our guarantee follows the Kingswell Guarantee standard: if the crown repair fails inside the covered period, we return and correct it at no charge. That’s the 365-Day Done Right Promise, and it’s included with every job as a matter of course. No add-on fee, no fine print. Nathan Corliss has been doing this work going on twenty-two years, and the guarantee is the same one he’d want on his own house.

DIY or Call Us?

There are a handful of things a homeowner can safely check from the ground: the visible condition of the crown from the yard, signs of rust staining on the fireplace wall, and whether the cap appears seated or tilted. That’s a fair homeowner inspection. What is not a safe DIY project is getting onto the roof of a two-story Marietta house to remove a crown, seat a new one, and seal it correctly while working at height on a surface that gets slick after morning dew. That’s how people end up in an urgent care clinic.

We work on steep-pitch roofs and two-story chases every week, and we still treat it as the most dangerous part of the job. If you can see the crown is failing but the roof line is steep, do not climb up there with a tube of sealant and a can-do attitude. The cost of a pro repair is a rounding error compared to a fall. Call (478) 796-8742 and let us handle it with the right equipment and the right fall protection. Tell you the price first, show you the work, put it in writing: that’s the whole job.

FAQs